WILLIAM R. (Bill) INGLIS, Australia
Bill sadly died in May 2009
With the approval of his family, this web site has been kept as a tribute
to him and his Meccano activities
Replica Channel Segments (part 119)
I first manufactured my Replica Meccano Channel Segments in 1969 as they
were a very scarce and much sought-after obsolete Meccano Part which had
not been made since before World War II. Their main uses were for large Flywheels
(11"+ diameter) for Stationary Steam Engine models and for Turntables for
Large Cranes, indeed Meccano Ltd. used Channel Segments for the prototype
Titan Giant Blocksetting Crane prior to their development of the Geared Roller
Bearing, P/N 167.
These Replicas sold well right up until I ceased my Replica activities in 1980, disposed of my Meccano Collection and stopped participating in Meccano Modelling for private reasons.
In 2001 some local Meccano Modellers/Collectors caught up with me and rekindled my interest in things Meccano. When I told them that my Channel Segment Tooling still existed I was encouraged to "dust off the die" and make a further run of my Replicas. Much to my surprise this run also sold very well showing that a considerable demand still existed for my Replica Meccano P/N 119's so I resolved to keep them in production for the time being, hence this web page.
|
|
Above: Original (top) and replica Channel Segments
Left: Flywheel built up from 2 circles of replica
Channel Segments |
|
|
These new parts, being from the same dies as my original replicas are identical
with them and are again finished in Nickel Plate. Their cost is $A35-00 per
set of 8 (there are 8 to a circle) plus postage. (This is for reference
purposes only. These parts can no longer be supplied since Bill passed
away).
(C) 2002-2009 - W.R.Inglis